There are 2 sets of measurement posted - one with the NLA peerless tweeter and one with the JF tweeter. The distortion around 2khz is much supressed in the plots for the JF tweeters - I had not noticed that the two graphs were for different tweeters.
I liked the primer video. I'd suggest adding a JF intro screen and more close ups. There's a bit of air noise and the volume is lower than other videos.
@jhollander said:
I liked the primer video. I'd suggest adding a JF intro screen and more close ups. There's a bit of air noise and the volume is lower than other videos.
Thanks for the feedback John. I have a wireless microphone on the way, that hiss is the heater in my shop, which I really don’t wanna shut it off when I’m doing the video but might have to. The editing thing I’m finding new tools to use with it every time I do a video.
Comments
the distortion around 2k seems to be reduced with the lower XO. How low can the JF tweeter go?
Edit: The tweeter is different between the 2 sets.
Not with new mic. I’ll do that this week.
https://www.jfcomponents.com/
https://www.jfcomponents.com/
What 2 sets? This is the first time I posted any measurements with the JF tweeter
https://www.jfcomponents.com/
There are 2 sets of measurement posted - one with the NLA peerless tweeter and one with the JF tweeter. The distortion around 2khz is much supressed in the plots for the JF tweeters - I had not noticed that the two graphs were for different tweeters.
Yes, two different tweeters and two totally different crossover points.
https://www.jfcomponents.com/
Looks like he has it on the product page:
https://www.jfcomponents.com/product-page/jf-1204f-4ohm-soft-dome-tweeter
That looks really good, Brad.
full distortion measurements are not available and would be good to be able to compare to the other tweeters Brad is testing.
I’ll redo the JF tweeter and post them in the IEC Test Baffle thread.
https://www.jfcomponents.com/
Then there was 2.
https://www.jfcomponents.com/
I liked the primer video. I'd suggest adding a JF intro screen and more close ups. There's a bit of air noise and the volume is lower than other videos.
Thanks for the feedback John. I have a wireless microphone on the way, that hiss is the heater in my shop, which I really don’t wanna shut it off when I’m doing the video but might have to. The editing thing I’m finding new tools to use with it every time I do a video.
https://www.jfcomponents.com/
YTmac-05 Final.
https://www.jfcomponents.com/
Part 1 of the video for it. I cut almost 40 minutes out of this. Part 2 in a few days.
https://www.jfcomponents.com/
Components and Drivers $140 Pair. Not bad.
https://www.jfcomponents.com/
A hair more than "a buck and a quarter staff"...
InDIYana Event Website